Page 1 of 1
Leg Printing
Posted: Fri Jan 23, 2009 4:42 am
by Remyth
Dear LEGO:
I love that printing is appearing on all sorts of legs now. Just about every theme has at least one set of printed legs and I think that that is great! Please continue with this!
Thanks,
Posted: Wed Jan 28, 2009 5:39 am
by DARKspawn
I'm of two minds about this one. I too really love the printed legs, but at the same time they reduce the reusability of the leg element. One might be hard-pressed working an Agents leg assembly into a castle MOC (not saying it's impossible
). But I really welcome the added details we have been seeing in minifigs recently, so I shouldn't complain.
Posted: Wed Jan 28, 2009 9:25 am
by Sir Nelson
DARKspawn wrote:One might be hard-pressed working an Agents leg assembly into a castle MOC (not saying it's impossible
)
As an aside, I'd like to see that... I don't recall seeing a 'seed part challenge' in quite awhile.
Posted: Wed Jan 28, 2009 10:00 am
by RichardAM
I agree- the recent ones to accompany the Wizards have been brilliant, and the Castaway Pirate is an excellent inclusion.
Like fleshies though, I seriously hope this stays as an alternative rather than becoming the norm, for the reason Aaron mentioned.
Posted: Thu Jan 29, 2009 12:25 am
by Remyth
I could not agree more. However, printed legs are definitely useful!
Posted: Thu Jan 29, 2009 12:43 am
by Athos
I'm not overly fond of the printed legs, because if the figure isn't just standing with his legs straight, they tend to look funny...
Steve