Black Knight Head Sticker

Sir Terrance · Post by **Sir Terrance** » Sat Jul 03, 2004 10:06 pm

Jamit e-mailed me about this one. He started it by doing the moustach, but he asked me to do the beard. I did, and here are the results. I do not deserve all the credit, since Jamit did the moustach, which to me looks like one of the hardest parts. Anyway: http://www.brickshelf.com/gallery/thebr ... t_head.bmp Enjoy!

jamitjames · Post by **jamitjames** » Sat Jul 03, 2004 10:38 pm

Very nice, I just con't get it

Dragon Master · Post by **Dragon Master** » Sun Jul 04, 2004 3:27 am

This is probably the worst one of the series, not that its bad persay, its just not very accurate at all.

DM

Post by **Formendacil** » Sun Jul 04, 2004 8:20 pm

Always loved this face (mainly because my brother had one, and I didn't, for YEARS)

But I don't really use it much.

Still, looks good.

jamitjames · Post by **jamitjames** » Mon Jul 05, 2004 11:20 am

Dragon Master wrote:This is probably the worst one of the series, not that its bad persay, its just not very accurate at all.

DM

For us or for LEGO

If us, whats wrong about it. We can always make it better.

Post by **Robin Hood** » Mon Jul 05, 2004 3:32 pm

Looks ok, but I think that the red colour is too brownish. Maybe lighten it up a bit. Also the whole head is to high up, maybe lower it a bit. Still looks good.

jamitjames · Post by **jamitjames** » Mon Jul 05, 2004 4:01 pm

Ok, I can do that aftar lunch...

Sir Terrance · Post by **Sir Terrance** » Mon Jul 05, 2004 4:40 pm

Robin Hood wrote:Looks ok, but I think that the red colour is too brownish. Maybe lighten it up a bit.

It really depends on the printer. For example, on my printer Anthony's red color shows up pink when printed, looks more like sand red. It will be slightly different with every printer.