Quick Question About Stickers
- Barbapple
- Steward
- Posts: 560
- Joined: Mon Jan 19, 2004 3:03 am
- Location: Small Town, Saskatchewan
- Contact:
Quick Question About Stickers
What is the size that you need to shrink one of Sava's torso templates too before printing it off?
[img]http://www.maj.com/gallery/barbapple/Stuff/animation1.gif[/img]
- Formendacil
- Knight Templar
- Posts: 4162
- Joined: Wed May 05, 2004 7:22 pm
- Location: Ashland, MA
- Contact:
In inches, they print at .60 across. I'm not sure what that is in metric, as our printer works in standard. Typically Canadian, to be sure. Usually though, I print at .65 inches, to give me a bit to trim with.
This shows the results of one such sticker:
http://www.brickshelf.com/gallery/Forme ... /elwen.jpg
I hope that helps. And I'm sure someone knows the metric numbers if you need them.
PS: Admins, should this be in Publishing?
This shows the results of one such sticker:
http://www.brickshelf.com/gallery/Forme ... /elwen.jpg
I hope that helps. And I'm sure someone knows the metric numbers if you need them.
PS: Admins, should this be in Publishing?
- Barbapple
- Steward
- Posts: 560
- Joined: Mon Jan 19, 2004 3:03 am
- Location: Small Town, Saskatchewan
- Contact:
Thanks alot! I'll post pics soon!
[img]http://www.maj.com/gallery/barbapple/Stuff/animation1.gif[/img]