Classic-Castle.com

This idea stemmed from a discussion on another forum as to the possibility of modding the new Lone Ranger carriage from 2 horses to 4. The suggestion also arose for 7188 King's Carriage so I thought I'd give this a try.


7188 King's carriage MOD by andhe , on Flickr


7188 King's carriage MOD close-up by andhe , on Flickr

Ideally it would have four matching horses, but I think I hid that well.

That's not bad at all!

To slim down the yoke between the pairs of ponies, you could use this clip:

and one of these plates

That would be basically identical to your setup, but 1 plate wide instead of two.

Thanks! I basically replicated the set-up from the original pair and moved it two the front horses.

Never seen this piece before
and having looked on bricklink I see it's only in 3 just released sets.

Hopefully it will crop up in some more sets (and in black) and I can snag a few. Alternatively I could split the 2 stud wide set up into two one stud wide 'bars'. I might break up the bulk a bit.

Having played around with this it quite makes me want to do a colour change and see what horses could be used (eg a pair of the grey printed MVR ones or even PoP ones).