Been building some more, again based on the parts that I have in abundance here. This time it was the 5 x 5 Facet Brick which I have in quantity from parting out the Rapid River Village set.
Using these bricks, i've come up with the following hexagonal tower:
This MOC also makes good use of the 1 x 6 x 5 printed bricks that I used extensively in the straight wall section. This MOC could probably be cleaned up a bit if I had a wider range of parts available to me. As it is, I had to take all of the 1 x 2 bricks off of my staight wall section just to make the tower!
From the back you can see that the top section of the tower is not actually a hexagon anymore. This was so that I could maintain the top of wall walkway. There is, as is typical for Lego design, no obvious way to get to the top of the tower! I'll have to work on that!
I think I may have to wait for the order I placed today to arrive before I make any further CCC modules. Perhaps an inside corner next, or maybe a gate. And then onto an adjustable geometry angles wall!
(who is obviously a bit excited about the new site!)